Ortur Laser Master 3 Vs xTool D1 Engravers Comparison
Here’s Ortur Laser Master 3 Vs xTool D1 laser engravers comparison that you may want to check out.
In case you don’t already know, Ortur Laser Master 3 laser engraver is a fast speed engraver and cutter that can do its job for up to 20,000mm per minute, with a cutting power of 10w. Those are pretty impressive numbers, especially if you check its competitors and the price they all sell at.
Movement Speed: For instance, if we pit Ortur Laser Master 3 versus its competitor like xTool D1, it can do same job at speed of up to 9600mm per minute and it’s priced up to a north of $800 compared to Ortur Laser Master 3 which costs just $699. What does speed translates into is xTool machine unable to exceed 9000mm/min. Once over 9000mm/min, the engraving process will go abnormal (issues may not appear at once, but they will come to the cases of engraving a large work or operating for a long time), such as glitch which leads to misalignment. But Ortur Laser Master 3 does not have this problem.
Appearance: xTool D1 Pro is available in red and gray colors while Ortur Laser Master 3 is available in classic gray, although a special edition of red and blue has just been launched for the later. It’s important to note that appearance is not a real factor that affects the choice of consumers, that’s why we compare the technicality of the two products next.
Operational Safety: If we compare them in safety, Ortur Laser Master 3 features Safety Lock, Active Position Protection, Sloping Position Protection, Exposure Duration Detection and Limitation, Voltage and Current Safety, Control System, Host Computer Watchdog and Emergency Stop Switch. xTool on the otherhand features no emergency stop switch and safety key, which does not meet the safety requirements. So it is great and potentially dangerous to laser engraving machines even users.
Engraving Grayscale: The grayscale engraving pictures of xTool almost have no gray transition, far from the grayscale engraving quality of Ortur Laser Master 3 engraver.
Operability: The firmware of xTool does not support changing any parameters. But Ortur firmware supports changes, so it has greater freedom of operation. The software of xTool is too simple, with fewer functions being only suitable for novices. Perhaps the biggest nightmare is that it is not compatible with the free software LaserGRBL, nor is it compatible with LightBurn very well. Ortur Laser Master 3 is open and compatible with these software, which is a huge win for Ortur machine.
You can check out Ortur Laser Master 3 laser engraver and cutter in action in the video embedded below.